3D Printer Calibration

Interested in Calibrating your 3D Printer? We've found the perfect open source page where you can find all of the necessary information to perform your own maintenance and calibration!

Calibration

Warning - Read carefully!

Every attempt has been made to ensure this is safe but ultimately there always is risk in running pre-sliced gcode from the internet. Preview the gcode in your slicer or Zupfe GCode Viewer and print at your own risk.

Only print this gcode when you are present, alert and capable of stopping the printer in case of emergency.

Validation has been built into the forms to only allow sensible min and max values, however this is not foolproof and Tinker Hive shall not be held liable or accountable for any damages caused to your printer. READ CAREFULLY AND PRINT AT YOUR OWN RISK! YOU HAVE BEEN WARNED!

Leave a comment

Please note, comments must be approved before they are published